I have a repeat region that filters out parts by parameters in each part. Most of the time, this brings in the correct parts with no problems.
However, occasionally when I open the drawing, only one or two parts show up. I have verified that the parameter used to do the filter is correct in each parts.
I also thought maybe this was due to not getting an AAX license, but I have verified that I do in fact have the correct license.
Has anyone else had this problem? When it works, it works great, but when it doesn't, it can be a pain.
Thanks in advance,
Jim
However, occasionally when I open the drawing, only one or two parts show up. I have verified that the parameter used to do the filter is correct in each parts.
I also thought maybe this was due to not getting an AAX license, but I have verified that I do in fact have the correct license.
Has anyone else had this problem? When it works, it works great, but when it doesn't, it can be a pain.
Thanks in advance,
Jim