dear sll,
I would like to change the mill surface in NC sequence by clicking on change option. But the mill surfaces are not highlighting (i thkni that is in blank status) & selection is not possible. I need to select the visibility option to unblank and then the selection is possible. Pls tell me why it blanks the surfaces?. Is there any config to have unblanked mill surfaces.
Thanks,
I would like to change the mill surface in NC sequence by clicking on change option. But the mill surfaces are not highlighting (i thkni that is in blank status) & selection is not possible. I need to select the visibility option to unblank and then the selection is possible. Pls tell me why it blanks the surfaces?. Is there any config to have unblanked mill surfaces.
Thanks,