Hello folks,
I have noticed that the estimate of the manuf.
time pro/nc is calculating (shown in the process manager screen) is off
from the real value, independently of the the model being manufactured.
I have not estimated the difference, nor if there is a constant ratio
between the real manuf. time and the estimate.
We have just noticed the estimate provided by proe (pro n/c) is never accurate.
what can I do to fix this?
is there a config. option that I should set??
best regards, any thoughts/ideas area appreciated.
Al.
I have noticed that the estimate of the manuf.
time pro/nc is calculating (shown in the process manager screen) is off
from the real value, independently of the the model being manufactured.
I have not estimated the difference, nor if there is a constant ratio
between the real manuf. time and the estimate.
We have just noticed the estimate provided by proe (pro n/c) is never accurate.
what can I do to fix this?
is there a config. option that I should set??
best regards, any thoughts/ideas area appreciated.
Al.