Morning,
I have 3 simple wires that I'm trying to manually route from points A to points B. They all at some point run though the same area and cable tied route.
My question is how do I get them to be seperate at this cable tied points? They are on top of each other and I know when i've done "imported" routes they space themselves out nicely so they are not on/into each other.
Is there a way to tell it "manually" to not be on each other or do I have to make seperate routes manually to space them out?
Any advice is appreciated.
I have 3 simple wires that I'm trying to manually route from points A to points B. They all at some point run though the same area and cable tied route.
My question is how do I get them to be seperate at this cable tied points? They are on top of each other and I know when i've done "imported" routes they space themselves out nicely so they are not on/into each other.
Is there a way to tell it "manually" to not be on each other or do I have to make seperate routes manually to space them out?
Any advice is appreciated.