Hi All,
I need to machine several tapered holes in an Alu plate
on the CNC mill using pro Nc Mill.
While the size is not critical (plus / minus 0.1mm) a
good surface finish is important.
A friend in another company says he can do this easily
with mastercam by machining the holes in a helical type
motion.
Therefore there are no steps like I get with Pro-E
(unless I use very small step depth, the hole has a 15
degree taper)
Is there anyway to do this in Pro-E?
thanks in advance.
I need to machine several tapered holes in an Alu plate
on the CNC mill using pro Nc Mill.
While the size is not critical (plus / minus 0.1mm) a
good surface finish is important.
A friend in another company says he can do this easily
with mastercam by machining the holes in a helical type
motion.
Therefore there are no steps like I get with Pro-E
(unless I use very small step depth, the hole has a 15
degree taper)
Is there anyway to do this in Pro-E?
thanks in advance.