Hi everyone,
I'm having difficulty with surface milling sequences. I can't get it to output as arc or helical (G02) even witha simply sequence. It outputs correctly for profile milling though. I have tried changing the acurracy and tolerance values. Not sure what else could effect it. Both the CL files and TAP files show point to point dataso that rules out the Post processor right?
I'm on wildfire 2 M050. If anyone can offer any advice I will be most grateful! Thanks and Regards
Cedric
I'm having difficulty with surface milling sequences. I can't get it to output as arc or helical (G02) even witha simply sequence. It outputs correctly for profile milling though. I have tried changing the acurracy and tolerance values. Not sure what else could effect it. Both the CL files and TAP files show point to point dataso that rules out the Post processor right?
I'm on wildfire 2 M050. If anyone can offer any advice I will be most grateful! Thanks and Regards
Cedric