Hi all,
I'm relatively new to SW and have a design question.
I have a design with a linear pattern of holes. My client has asked if it possible to make the same part, but with 3 of the existing holes to a different diameter than the others.
When I did the original design I simply made one hole and then patterned it. I can go back and modify the pattern and such, but would rather avoid the extra work.
My question is if there is a way to modify individual members of a pattern?
I'm using SW2007.
Thanks,
Lance
I'm relatively new to SW and have a design question.
I have a design with a linear pattern of holes. My client has asked if it possible to make the same part, but with 3 of the existing holes to a different diameter than the others.
When I did the original design I simply made one hole and then patterned it. I can go back and modify the pattern and such, but would rather avoid the extra work.
My question is if there is a way to modify individual members of a pattern?
I'm using SW2007.
Thanks,
Lance