Hello all,
I am trying to makea rectangular protrusionwith rounded the cornersof equal radii into a flexible component. I want to vary the length and width and the radii.
I want to write a relation to control the radii so that it can not be greater than half of the length or width.
Example:
d1>d2, r (d3)can not be greater than d2/2
if d1< d2, r can not be greater than d1/2
and if d1=d2, than r can not be greater than either d1/2 or d2/2
My vba skills are non existant so any help with writing the relation would greatly be appreciated.
Wildfire 3
Thank you.
Edited by: tdx99
I am trying to makea rectangular protrusionwith rounded the cornersof equal radii into a flexible component. I want to vary the length and width and the radii.
I want to write a relation to control the radii so that it can not be greater than half of the length or width.
Example:
d1>d2, r (d3)can not be greater than d2/2
if d1< d2, r can not be greater than d1/2
and if d1=d2, than r can not be greater than either d1/2 or d2/2
My vba skills are non existant so any help with writing the relation would greatly be appreciated.
Wildfire 3
Thank you.
Edited by: tdx99