Hi everybody!
I have an assembly (an arm for excavator equipment) and I don't know
certainly which are the steps for analyse this assembly. I work in
promech integrate in proe (wildfire 2.0) and after assign material, new
displacement constraints load, new forces (or momments), create new
study and run this study I get a error mesage. And I create mesh for my
assembly and run again new study I obtain a new error message. I must
have same rigorous conditions for parts of assembly, just like weldment
for mate? What are wrong and why? Have somebody some lessons or
tutorials where are explained this problem.
Thanks in advance!
Bye
I have an assembly (an arm for excavator equipment) and I don't know
certainly which are the steps for analyse this assembly. I work in
promech integrate in proe (wildfire 2.0) and after assign material, new
displacement constraints load, new forces (or momments), create new
study and run this study I get a error mesage. And I create mesh for my
assembly and run again new study I obtain a new error message. I must
have same rigorous conditions for parts of assembly, just like weldment
for mate? What are wrong and why? Have somebody some lessons or
tutorials where are explained this problem.
Thanks in advance!
Bye