GD&T Datum references

[jelston]

I'm just starting to use datum references in Pro/E.I have not been able to get the datum reference box to show up on my drawing however. Any ideas?

 

[Guest]

I've used them a little and there are a couple of things that come to mind. Are you trying to add the gtol to an added dimension? If so you need to set the Modeldrop down box to The Drawing. You will also need to setup draft datums and change them to Datum Refs so that they show up under the Datum Refs tab of the Geometric Tolerance dialog box.

 

[jelston]

I got them to show up. It's kinda quirky, but when i figure out for certain, I will post it.