Hello All,
I am just curious your opinion about this feature issue. If you have a flat
surface with a round (arc) piece and you extend the surface at this edge, the
result won’t be round (arc) anymore. I used Wildfire 2.0 M090. In my opinion
this should not work like this. I tried to ask PTC, but they answered first:
this is fixed in the next built - I use M190 now, but still not works good.
Second time they answered this is because of the algorithm calculates the
result point by point. Could anybody try this in Wildfire 3.0 please? Just for
my curiosity. Thanks,
Peter Bo
View attachment 2782
View attachment 2783
I am just curious your opinion about this feature issue. If you have a flat
surface with a round (arc) piece and you extend the surface at this edge, the
result won’t be round (arc) anymore. I used Wildfire 2.0 M090. In my opinion
this should not work like this. I tried to ask PTC, but they answered first:
this is fixed in the next built - I use M190 now, but still not works good.
Second time they answered this is because of the algorithm calculates the
result point by point. Could anybody try this in Wildfire 3.0 please? Just for
my curiosity. Thanks,
Peter Bo
View attachment 2782
View attachment 2783