Hi Guys and Girls,
A question, I have used Pro-E since V2000, and have just returned from New Zealand where I have been working for 2 years, using Solidworks. I'm back now on WF2 and doing some sheetmetal stuff. The issue I have is, i'm trying to create a sheetmetal part with 2 flanges, very simple, the only thing is that WF2 doesn't have an option in the dashboard to create the finished corner I require, i.e. No Rip where it meets the other flange wall, it's hard to describe so see the JPG's below, the 1st is the result I want and the second is what I don't!!! In Solidworks Sheetmetal there were about 3 or 4 options while creating this type of wall and you could get the result I want no worries. I might have missed a option or something if so please educate me!!
Cheers Rob
This is the result I want, i got this by extruding an unattached wall and then merging.
View attachment 1454
This is what the options produce in the dashboard.
View attachment 1455
A question, I have used Pro-E since V2000, and have just returned from New Zealand where I have been working for 2 years, using Solidworks. I'm back now on WF2 and doing some sheetmetal stuff. The issue I have is, i'm trying to create a sheetmetal part with 2 flanges, very simple, the only thing is that WF2 doesn't have an option in the dashboard to create the finished corner I require, i.e. No Rip where it meets the other flange wall, it's hard to describe so see the JPG's below, the 1st is the result I want and the second is what I don't!!! In Solidworks Sheetmetal there were about 3 or 4 options while creating this type of wall and you could get the result I want no worries. I might have missed a option or something if so please educate me!!
Cheers Rob
This is the result I want, i got this by extruding an unattached wall and then merging.
View attachment 1454
This is what the options produce in the dashboard.
View attachment 1455