praveen1986
New member
I am working in a company which is in
sheet-metal development & manufacturing.
We use ProE WF4.0. I have created one template in which I
added general & projection views of the part.
A title block With date, scale, thickness parameters.
I want to insert a flat state (blank, unbent) of the part
on same drawing sheet. These blank than we need to give
to manufacturing department.
Currently we do blanks through
Edit->Setup->ShtMetal->FlatState->Fully Flat & put it
into drawing sheet. Since we are in sheetmetal, we need
to develop hundreds of blanks everyday & this becomes a
very time consuming & long procedure to this.
There must be some trick, some parameter, some programme
which will make my work easier.
All experts from mcadcentral.com, Take this as a
challenge & solve this issue.
Once again briefly I want to explain, I want to create a
template with bend part views & flat state (unbent) view
coming automatically in my drawing.
I know litle about parameters & programmes, so if there
is any way please explain me.
sheet-metal development & manufacturing.
We use ProE WF4.0. I have created one template in which I
added general & projection views of the part.
A title block With date, scale, thickness parameters.
I want to insert a flat state (blank, unbent) of the part
on same drawing sheet. These blank than we need to give
to manufacturing department.
Currently we do blanks through
Edit->Setup->ShtMetal->FlatState->Fully Flat & put it
into drawing sheet. Since we are in sheetmetal, we need
to develop hundreds of blanks everyday & this becomes a
very time consuming & long procedure to this.
There must be some trick, some parameter, some programme
which will make my work easier.
All experts from mcadcentral.com, Take this as a
challenge & solve this issue.
Once again briefly I want to explain, I want to create a
template with bend part views & flat state (unbent) view
coming automatically in my drawing.
I know litle about parameters & programmes, so if there
is any way please explain me.