When I pull views from a part in a drawing the orientation is backwards to how I would like it. Here is an image of what happens when I use the Projected View command.
View attachment 5926
Here is what my drafting standards is set to, but no matter what I change it too the views still pull the same.
View attachment 5927
And this is what I would like my projected views to pull like.
View attachment 5928
Any instruction on how to correctly adjust the settings for the desired results would be greatly appreciated.
View attachment 5926
Here is what my drafting standards is set to, but no matter what I change it too the views still pull the same.
View attachment 5927
And this is what I would like my projected views to pull like.
View attachment 5928
Any instruction on how to correctly adjust the settings for the desired results would be greatly appreciated.