Hi,
I am an absolute novice at Pro engineer. I have basically
been trying to create the 2D profile of the Porsche 911
GT3 RS in Pro Engineer. I clicked on creating a new part,
however by the time I had finished and wanted to save the
the file as a .prt file (to be able to then import into
Ansys) for some reason the file is being saved as a .sec
file. I have search through tutorials and forum on the
net to try to resolve this issue. The problem i am
finding is that there is no "check" icon on the bottom
right hand side to be able to finalised the design. If
anyone could help it would be much appreciated.
Cheers
I am an absolute novice at Pro engineer. I have basically
been trying to create the 2D profile of the Porsche 911
GT3 RS in Pro Engineer. I clicked on creating a new part,
however by the time I had finished and wanted to save the
the file as a .prt file (to be able to then import into
Ansys) for some reason the file is being saved as a .sec
file. I have search through tutorials and forum on the
net to try to resolve this issue. The problem i am
finding is that there is no "check" icon on the bottom
right hand side to be able to finalised the design. If
anyone could help it would be much appreciated.
Cheers