Is it possible to show "pma" conduit in a cable harness assembly without making the assembly overly complicated?
(ie trying to pattern along a curve following the cabling network)
If this is possible can I show it in the flat harness assy?
I could use a sheath or bundle, but my technical publication department would like to see the corrugated pma conduit in the assembly.
Thanks
(ie trying to pattern along a curve following the cabling network)
If this is possible can I show it in the flat harness assy?
I could use a sheath or bundle, but my technical publication department would like to see the corrugated pma conduit in the assembly.
Thanks