CFG error help

[red devil]

Whenever I load up a part, I get theerror message shown below. I have looked in my config.pro, config.win, but I cannot find where these errors come from. Does anyone have any ideas? I am running WF2.


This is from the error file cfgerror.txt


Line 9: Unknown keyword COMPS.
Line 10: Unknown keyword BT_BODY_CONNS.
Line 11: Unknown keyword BT_INCOMING_CONNS.
Line 12: Unknown keyword BT_BODY_CONTS.
Line 13: Unknown keyword BT_MOTION_AXES.
Line 14: Unknown keyword ENVELOPE.
Line 15: Unknown keyword COMP_PLACEMENT.



Thanks in advance


Jeff

 

[Jacoolo]

funny, I saw similar problem on other forum

from the post I read, I know it was caused by model tree congig file.

Check it, maybe same here...

 

[dgs]

Yep, check you model tree config file. It's likely from an older version, if your tree looks like you want it, try re-saving the config file. That should clear the old stuff and stop the errors.

 

[red devil]

Yay, top man Jacek!


That's got it sorted. I think I know where the probelm lies. The original tree.cfg file was created with Wildfire3, when I installed a copy of Wildfire 2 (for another client) I copied that same cfg file. There must be some commands in Wildfire 3 that Wildfire 2 does not recognise.


All sorted!


Many thanks


Jeff