mjcole_ptc
New member
I find it annoying that you can no longer create incomplete features.
This used to be a good option when defining a feature that requires additional reference curves that you might want to use for a Variable sweep or any other feature.
With incomplete features you could select all the references you wanted such as Origin Trajectory and Constant or Variable section and any other references that have been created and then leave the feature incomplete and come back to redefine it later.
As it is now on WF2 If you had gone through the selection of your references and noticed that one was missing, you have to cancel out of the feature and waste time or select garbage references to finish the feature incorrectly.
It's a shame to have to watch the quality of Pro/E go down the tubes when useful functionality gets removed just to be put back later.
Michael
This used to be a good option when defining a feature that requires additional reference curves that you might want to use for a Variable sweep or any other feature.
With incomplete features you could select all the references you wanted such as Origin Trajectory and Constant or Variable section and any other references that have been created and then leave the feature incomplete and come back to redefine it later.
As it is now on WF2 If you had gone through the selection of your references and noticed that one was missing, you have to cancel out of the feature and waste time or select garbage references to finish the feature incorrectly.
It's a shame to have to watch the quality of Pro/E go down the tubes when useful functionality gets removed just to be put back later.
Michael