Axis table

[Andrew1981]

Hi Sir's, I havea axis table too much long, I want cut itor dividein two or three parts, so that I can put it into drawing


Some body can help me, thanks

 

[SRINIVASANIYER1]

One could paginate BOM tables, but i am not sure about
paginating Axis tables. Try it. My proe is not open now.

 

[Andrew1981]

Hi, Already tried with the option paginate, but the problem was which a wanted seccionate the axis table on the same page. the temporal solution was copy table and cutted the rows on the correct places,


thanks for your support,


Regarda

 

[kdem]

You can specify the number rows before creating the table under Hole Table>Set Up. It only works with initial setup though so you need to recreate the hole table. When the table gets to the maximum number of rows ProE prompts you for a table location and will continue to do so until all holes that can be placed in the table are there. If you add more holes to the model when you update the table the new holes will be appended to the last table created.