assembly reported mass properties

[flwad]

I am trying to set up some relations to use the mass properties of my assemblies, but the reported mass properties for all assemblies are still '0.' My parts seem to show proper values, but even after running an assembly mass properties analysis, I still don't have any values. I'm using WF2.


Any suggestions?

 

[brunoth]

Hi did you try this topic ?


[url]http://www.mcadcentral.com/articles/anmviewer.asp?a=23&z =2[/url]


it runs.

 

[flwad]

Thanks for the input. But...


This technique requires Behavioral Modeler which we don't have.


I was looking for something that can be done with the base program.

 

[ehorton]

Try going to Edit-->Setup-->Mass Props-->Generate, then run your Model Mass Properties and then regenerate. Then you should be able to go into your parameters and see if the weight has changed. Hope this helps.

 

[Jacoolo]

What about ordinary relation MASS=mp_mass("")*1000 - kilograms as a mass unit

 

[brunoth]

Hi


look at this topic ! maybe useful for you.

[url]http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=27 760[/url]


I hope that helps


regards