Greetings all,
I'd like to set the offset dimension of a plane in an assembly relative to a parameter of a part in the assembly.
In pre-CREO versions I knew the format and how to get the session ID of the part.
I'm betting the format hasn't changed.
Although, how to 'switch dims to get the session ID is another story.
How can I get the session ID of the part?
TIA,
PLQ
I'd like to set the offset dimension of a plane in an assembly relative to a parameter of a part in the assembly.
In pre-CREO versions I knew the format and how to get the session ID of the part.
I'm betting the format hasn't changed.
Although, how to 'switch dims to get the session ID is another story.
How can I get the session ID of the part?
TIA,
PLQ