Barbarpapa1
New member
Hello all
I'm not quite new into Pro/Mechanica but until recently I did only
single part analysis. Right now I have to perform stuctural analysis to
an assembly. The assembly itsef is quite simple one. It consist from
two parts, which are made from different materials with quite different
properties. I can assign desired material to each part part while in
Pro/Mechanica (Integrated mode), but when I intent to start the
analysis it claims that there is no material assigned and stops.
Now I'm wondering, where I'm doig something wrong? Should I assign the
material while modelling parts in Pro/E? How can I do this in
Pro/Mechanica?
I'm using Wildfire2 and Pro/Mechanica in integrated mode.
Thanks
Kind regards
Joze
I'm not quite new into Pro/Mechanica but until recently I did only
single part analysis. Right now I have to perform stuctural analysis to
an assembly. The assembly itsef is quite simple one. It consist from
two parts, which are made from different materials with quite different
properties. I can assign desired material to each part part while in
Pro/Mechanica (Integrated mode), but when I intent to start the
analysis it claims that there is no material assigned and stops.
Now I'm wondering, where I'm doig something wrong? Should I assign the
material while modelling parts in Pro/E? How can I do this in
Pro/Mechanica?
I'm using Wildfire2 and Pro/Mechanica in integrated mode.
Thanks
Kind regards
Joze