Angle extrusion

[Art1]

I m a begginer with proe 4, and I m trying to remove material from inside of a tube 40 mm thick but this have to have and angle of 15

 

[TS3g]

I guess I don't fully understand what you are trying to do, but it sounds like a revolved cut is what you want.

Edited by: TS3g

 

[tobbo]

...or place your cut on a angeld datumplane?


Do you haveany sketches or pics that you can upload?


//Tobias

 

[jvidal]

..or maybe you need a draft?

 

[Art1]

[No message]

 

[Art1]

I want to try to remove this section but with an angle of 15 degrees, the 2 black line are made with paint.


Hopefully this will expalin better what I m trying to do


thanks

 

[zpaolo]

From what I see in the picture it should be quite easy, just sketch on the front face of the cylinder, draw the section you need to remove. Be sure to select from the dashboard "solid" instead of "surface" and "remove material" instead of add material. Also check if arrows for extrude direction and material remove are correct...

Paolo

 

[Art1]

If I do what do you suggest I won t have 15 degrees on the left. I mean the
sketch on the back datum have to be displaced 15 degrees from the front
datum.

 

[zpaolo]

If I do what do you suggest I won t have 15 degrees on the left. I mean the

sketch on the back datum have to be displaced 15 degrees from the front

datum.

Oh, now I understand! in this case you can create a plane angled 15

 

[Art1]

Now it should works, I will try it, thanks

 

[zpaolo]

Probably, being a cylindrical surface, the 15

 

[dr_gallup]

You can do it pretty easily with a helical sweep.


2009-07-08_162910_prt0001.prt.zip