michael3130
New member
Hi,
My datums in sketch mode are messing about.
If I look normally at the sketch, sometimes the right and top datum lines go haywire, they should be horizontal aand vertical but go off at funny angles. As I zoom in and out they change from being ok to being at angles at random. Turning the planes off seems to realign them.
This has only happened since I got a new machine last week. It's a Dell Precision T3600 with Intel Xeon CPU 3.6Ghz, 16.0GB of RAM, 64 Bit with an Nvidia Quadro 4000 graphics card. It was specced for use with Creo 2 but I haven't moved to Creo 2 on this machine yet as I'm waiting for the other guys in the office to have their machines upgraded too. I'm currently using WF4.
It's obviously an issue caused by the new machine as I've never seen this before but would like to know if anyone else has seen anything like it and what the route cause is. Hopefully it wont be an issue when we move to Creo 2.
I've attached a couple of images of it normally and when it messes up.
Thanks
Michael
My datums in sketch mode are messing about.
If I look normally at the sketch, sometimes the right and top datum lines go haywire, they should be horizontal aand vertical but go off at funny angles. As I zoom in and out they change from being ok to being at angles at random. Turning the planes off seems to realign them.
This has only happened since I got a new machine last week. It's a Dell Precision T3600 with Intel Xeon CPU 3.6Ghz, 16.0GB of RAM, 64 Bit with an Nvidia Quadro 4000 graphics card. It was specced for use with Creo 2 but I haven't moved to Creo 2 on this machine yet as I'm waiting for the other guys in the office to have their machines upgraded too. I'm currently using WF4.
It's obviously an issue caused by the new machine as I've never seen this before but would like to know if anyone else has seen anything like it and what the route cause is. Hopefully it wont be an issue when we move to Creo 2.
I've attached a couple of images of it normally and when it messes up.
Thanks
Michael