hello everyone,
i have been trying to thermal analysis on pro mechanica
in the native mode. Am doing a thermal analysis on a
electric vehicle gearbox housing. Everytime i start the
run, It stops with a fatal error in the meshing phase
without mentioning the place of the error.
( Error message:
Mechanica could not generate elements for all of the
entities in the model. Use the Info->Diagnostics
menu to review detailed messages and problem areas).
And there is this whole confusion that the model gets
meshed properly in the FEM mode and i do not know how to
proceed with the analysis in that mode.
Am not able to figure out where the problem is so that i
can correct it.. can some one help me with this??
i have been trying to thermal analysis on pro mechanica
in the native mode. Am doing a thermal analysis on a
electric vehicle gearbox housing. Everytime i start the
run, It stops with a fatal error in the meshing phase
without mentioning the place of the error.
( Error message:
Mechanica could not generate elements for all of the
entities in the model. Use the Info->Diagnostics
menu to review detailed messages and problem areas).
And there is this whole confusion that the model gets
meshed properly in the FEM mode and i do not know how to
proceed with the analysis in that mode.
Am not able to figure out where the problem is so that i
can correct it.. can some one help me with this??