STRANGE

[cristelino]

So i have an assembly.........


I dont know what happened but for one single part DONT ACCEPT INSERT FEATURE IN ASSEMBLY MODE


WHY?

 

[Israr]

may be parent-child relation problem.


Israr

 

[Moroso]

Is the part activated, assuming your using WF1 or 2

 

[skraba]

In WF2, activate part and start creating geometry (e.g. Insert > Extrude).

 

[cristelino]

The parts i talk are created and opened in 2001

 

[cristelino]

iS NOT ABBOUT ACTIVATE


1)I can see the part only in Shading mode


I can t mesure a distance for example between an edge of this part and one another


Are displayng only de edge in Hidden mode


I can modify only in Part mode

Can be a frozen layer or something?


Is the first time in 8 years i see something like that


Is very frustrating because i dont know what s happened and a i can t do something because everything i did ........is nothing happened


Is possible to debbug or something? because is very complex part and is difficult to remade


Cristelino

Edited by: cristelino

 

[dsergison]

is it frozen, packaged, or not constrained properly?

 

[indigo2]

Cristelino -


Sounds like you might have some kind of Simplified Rep defined for your assembly. Perhaps your part is set to Graphics Rep, or Geometry Rep, rather than the Master.


-tsl

 

[cristelino]

thanks for your reply


I made a beginner mistake.............


Indigois right sipmlify representation was the problem


I have impresions more i advance more i forget the simple things

i have simplify reperesentation in assembly................. but i nevermade it


After 8 years Proe i found simple problems very complicate


Cristelino






Edited by: cristelino