I am trying to create a whisk.
Would it be possible to create the 'spacer' as a skeleton model so i could control the number of wires? At present i have datum points at the center of each hole in the spacer, this is what im using to control the datum curves. The curves are what i use to sweep a protrusion along to create the solid wires.
View attachment 43
Im unsure how i would go about this?
Would it be possible to create the 'spacer' as a skeleton model so i could control the number of wires? At present i have datum points at the center of each hole in the spacer, this is what im using to control the datum curves. The curves are what i use to sweep a protrusion along to create the solid wires.
View attachment 43
Im unsure how i would go about this?