sheet metal bending and unbend

[sdshriram]

Dear all,


help require...how I can unbend this part in sheet metal. thickness is 1.8 mm


Sudhir


View attachment 5469

 

[s_pme20]

I wonder..how will you physically create this part from the piece of sh*t (sheet..

) ???

 

[telecomguy]

Could you not rip along these lines and then unfold? I am assuming there's a bottom to the box. But I agree, forming up this part is going to be a challenge to say the least...


View attachment 5470
Edited by: telecomguy

 

[seth505]

Yes, like mentioned above you would need to create edge rips (and probably rip connects) so the part can be physically unfolded