I am looking to flatten a ribbon cable. When routing the ribbon cable, it appears you have to start at a singleentry portin the center of the connector and then attach to a network following pin 1. I can get the cable modeled this way. When I flatten, the center location attaches to conductor 1 and the connector is offset from the cable??
Has anyone been succesful with ribbon cables and can give some pointers?
Wildfire 4
Creo Schematics 1
Thanks,
jef
Edited by: jstone
Has anyone been succesful with ribbon cables and can give some pointers?
Wildfire 4
Creo Schematics 1
Thanks,
jef
Edited by: jstone