I would like to ask the wisdom of the forum. I would like to build a BOM on a drawing verymuch like it appears in the model tree but grouping the hardware for any given piece just after it. I know I can do this using no duplicates and each and every instance of a part shows up in the BOM with a quanity of 1. Is it possible to group identical parts (screws, nuts etc) like this.
1 of Part A
3 of Screw B
2 of nut C
1 of part D
5 of Screw B
5 of Nut C
1 of Part E
17 of Screw B
Creo 2.0
Build m020
Thanks in advance
Peterh
1 of Part A
3 of Screw B
2 of nut C
1 of part D
5 of Screw B
5 of Nut C
1 of Part E
17 of Screw B
Creo 2.0
Build m020
Thanks in advance
Peterh