design-engine
New member
The good old ribbons connecting your computer HD to your mother board.... I routed an entire assembly of harnesses and I do want to utilize Pro/CABLE for the remaining mylar flex cable and silver ribbon cable.
There is a setting under network operations for 'Cable Envr' for round vs flat. Dont think thats the setting im looking for?
Im in WF3.0 at the moment. I think WF4.0 lets us do flat ribbons right?Anyone care to make a discussion on ribbons and flex circuit ribbons.
Im about to just do it in Pro/SWEEP and get-her-done mode but I routed the entire assembly harnesses with RSD and CABLE and I am not about to give up now and just sweep it.comments?
I did route this ribbon with Pro/CABLE but cheated using multiple 'network ops'.
Edited by: design-engine
There is a setting under network operations for 'Cable Envr' for round vs flat. Dont think thats the setting im looking for?
Im in WF3.0 at the moment. I think WF4.0 lets us do flat ribbons right?Anyone care to make a discussion on ribbons and flex circuit ribbons.
Im about to just do it in Pro/SWEEP and get-her-done mode but I routed the entire assembly harnesses with RSD and CABLE and I am not about to give up now and just sweep it.comments?
I did route this ribbon with Pro/CABLE but cheated using multiple 'network ops'.
Edited by: design-engine