please help with vss

[arroyopr]

please help complete the vss. as shown in the part uploaded, I'm encounting problems finishing the vss feature. I created dtm curves for trajectories. Your support/advice is greatly appreciated.


thanks


arroyopr


2009-09-22_103448_33583-939091.prt.zip

 

[jsantangelo]

Can you describe what you are trying to achieve?

 

[arroyopr]

Dear James,


As you can see, the pocket were the rounds are isn't deep enough for a full round. and varies from .38 to .50 inch, apperently is just a portion of the ball endmill.BTY this was a forging part. And trying to make it a machinable one. Is a very critical part for an aircraft landing gear. If you can acomplish this process with another type of feature you are more than welcome to give ita shot.


Thanks


Bill

 

[abrazors]

this is a quick try, resulting surface isn't totally "clean" but I think what you are going after...





2009-09-24_100308_33583-939091.prt.zip

 

[arroyopr]

Dear Abrazors,


I'm not able to retrive your part. Is your're license newer than wf2 or educ.? if so could please send me a iges,neutral, or something comperable with pro-e?


thank you


Arroyopr