NC Sequence Param. Window setup

[marker4x4]

Hiall,



I wonder if anyone knows about the way of customizing the Param. window
in the NC Sequence sub-menu. ProE will let you chose between Simple and
Advanced, now how about Custom?? I guess, it has something to do with SITE that needs to be created prior to do anything else.



I'm getting annoyed of scrolling through pages of nonsense parameters just to set my lead-in rad or something like that.



Thanks for looking



Edited by: marker4x4

 

[cncwhiz]

Marker 4 x 4,


If you build a parameter "site" you can config it to pre-configure almost any parameter that you want. Lets say you do a milling cut anduse the same cutter comp, lead radius etc you build a site for this. Now when you go to program that type of tool you click on the "site" in the parameter menu and pick the one you want. If you want to make somes changes then you can make them or just click done. Feel free to contact me if you need any more info.

 

[marker4x4]

Marker 4 x 4,


If you build a parameter "site" you can config it to pre-configure
almost any parameter that you want. Lets say you do a milling cut
anduse the same cutter comp, lead radius etc you build a site for
this. Now when you go to program that type of tool you click on the
"site" in the parameter menu and pick the one you want. If you want to
make somes changes then you can make them or just click done. Feel free
to contact me if you need any more info.

Thanks Whiz, I gave it a try today and it seemed to work; I just need to develop the habit to actually use it, hahaha



Thanks again

-mark