Hi guys, i'm hoping someone can recommend the best method for modelling a curved tube in which the diameter narrows gradually around its circumference
It is for a micro-hydro turbine project at uni and the picture shows the files i was given to improve upon which are crude
it starts off at 22mm inner diameter and narrows to 10mm after 270 degrees at which point the diameter is constant up untill it rejoins
hope someone can help me plz
Edited by: mkitch
It is for a micro-hydro turbine project at uni and the picture shows the files i was given to improve upon which are crude
it starts off at 22mm inner diameter and narrows to 10mm after 270 degrees at which point the diameter is constant up untill it rejoins
hope someone can help me plz
Edited by: mkitch