Modelcheck from Intralink

[peter_hajdu]

We use PROE WF2 with Intralink3.4 and have a strict rule at our company: we have to run ModelCHECK on all the modified models and drawings in PROE before we check in to Commonspace. We have to do it before every check in process.
<?:namespace prefix = o ns = "urn:schemas-microsoft-comfficeffice" />
Does anyone has an idea how to run this Modelcheck process from Intralnik in some

 

[looslib]

Change your modelcheck settings so it runs AT save time. Then all files will have been checked before saving. You can even set it up so that if the file fails the modelcheck process, it will not save.

 

[jnoval]

You can use Innotiv freesbatch tool.


[url]http://www.spekan.com/innotiv/index.php?mnu=dwnl&sub=bat ch[/url]

 

[peter_hajdu]

Hi jnoval


I tried to download the tool 3.2 from this server but I got the message: this URL is not available in this server.


Is there any other place I could find?


Or what to set in config pro to run the modelcheck on savint the files?





Regards

 

[jnoval]

Yes they have move the download to another site because the had a lot of problems with downloads. I cant remember where it is. Sent them a email, and they will reply with the correct url. If you diden't get a reply just write here again and I will find it somewhere to you.


I think you set modelcheck to run on save in one of the modelcheckconfigurations files.

 

[jnoval]

Here you can get sbatch:


http://spekantools.innotiv.nl/index.php


They even have a forum.