mass properties

[rajendran]

Dear All,


Is there any way to limit the decimal places of mass calculated through mass properties in Pro/E.


Thanks.

 

[garymig]

i have only found you can change it in the drawing mode


as a parameter '&PRO_MP_MASS[.1]', where the '.1' is the number of decimal places.


dont know if that helps,


Gary

 

[audctrl]

If your talking on the drawing, yes


&pro_mp_mass[.2] number indicates number of decimal places

 

[rajendran]

Thanks for your reply. We hava a parameter mass (mass=pro_mp_mass). I need to truncate decimal places in this part parameter value not in drawing. Is there way to make it?


Thanks