Hi,
I have installed Wildfire 3.0 M050 build plus I have also experienced the same problem below with the M03 build( upgraded thinking it might have cured it !!)
I desperately need a fix for this problem I outline.
I have created an assembly of a rack system with an excess of 500 parts in it. Many of the parts are duplicates of parts already used within the assembly, in total there are probably a maximum of 100 unique parts.
The filesize of the *.asm is only about 350k, Its using up over 2Gb of Ram before it crashes. (I have 2GB ram and 3070MB virtual memory available) So I dont think its a memory problem.....
Simply it gets to a point of saying its regenerating upon load but then crashes before it actually does ?
Edited by: Canners
I have installed Wildfire 3.0 M050 build plus I have also experienced the same problem below with the M03 build( upgraded thinking it might have cured it !!)
I desperately need a fix for this problem I outline.
I have created an assembly of a rack system with an excess of 500 parts in it. Many of the parts are duplicates of parts already used within the assembly, in total there are probably a maximum of 100 unique parts.
The filesize of the *.asm is only about 350k, Its using up over 2Gb of Ram before it crashes. (I have 2GB ram and 3070MB virtual memory available) So I dont think its a memory problem.....
Simply it gets to a point of saying its regenerating upon load but then crashes before it actually does ?
Edited by: Canners