line thickness

[Blaze]

I have 3 lines lies very close to each other. When printing, they becomes one thick line. I mean not the dimension lines, but the lines of the geometry (part).


So i decided to change the thickness to avoid this merging. But i cannot find out how to do this.

 

[ankarl]

You can adjust the plot thickness by altering the values in your pen table file.


The location of the file is specified by "pro_plot_config_dir" or "pen_table_file"
in your config.pro


regards
/Anders
Edited by: ankarl

 

[ndk]

we had some thread on this issue.


[url]http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=25 992&PN=9[/url]


hope it helpful.

 

[Blaze]

thanks a lot!