How to prevent sketcher from zooming out

[Edo07]

Hello all,


Every time I change a dimension in a sketch andProE regenerates it, the image is zoomed out - often to a level beyond what I'd achieve with Fit To Screen. I work on large assemblies, and this little stunt has become incredibly annoying, as I spend half of the time zooming back to where I wasworking!

Does anyone know whether (and where) there might be an optionI can change to stop this? Iam using Pro/E Wildfire 2.0.


Many thanks in advance,


Edoardo

 

[dgs]

sketcher_refit_after_dim_modify no

 

[Edo07]

Doug,


That was it! The dream of a lifetime (well, almost) comes true...

Thank you so much!


Edoardo

 

[prohammy]

Edo07,


Slightly off topic, but here is another config setting that I lave to use (especially good when you are a large assembly)


sketcher_starts_in_2d - yes/no


Stops ProE re-orientating the sketch onto a 2-d plane


Kev

 

[Edo07]

prohammy,


Thanks for this one as well! ProE is really full of small quirks that arehard to find...


Edoardo
Edited by: Edo07