GUIDE BUSH OFFSET IN EMX

[AASIM]

I have defined a new EMX project with Moldbase type set to MFG. I assembled a Guide Bush which is offset from its reference by 10mm as shown in the figure below


View attachment 447
Now the EMX does not create the BORE HEAD DIA and DEPTH in the workpiece according to the head size of the bush as shown below.
View attachment 448
Thanks in advance.
Asim Rashid

 

[tdegroot]

I too have found emx to sometimes not create the geometry the way that I think that it should. In those instances, just go and modify the geometry manually, you will save yourself alot of frustration. This is just my opinion.