Edge display problem in assembly drawing

[Rickard]

Hello!

I have this problem that's been bugging me for a while. Sometimes when I create a drawing the edges of the part or assembly comes out wrong.

For example, the bottom plate of this weld asm has two holes that the keys go into, but both of them are shown wrong.


This is how it's supposed to look:


Any suggestions would be much appreciated!

 

[krow72]

Is there any interference between the 2 features? I have seen this happen when 2 features overlap.

 

[srieger]

This will usually occur when the parts actually have interference with each other.

 

[Rickard]

I've been on vacation, sorry for the late answer.

The parts have small interference zones, so it seems you were spot on.

Thanks for the help!

 

[krow72]

That was a long vacation...lucky you . Glad we could help you out.