Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.
1. Use conservation of energy in order to determine final velocity just before touching ground.
2. Run a static analysis with constraints that represent where the object will hit the ground. Apply a colinear load with the direction of drop. Get the defelction caused by these set of loads & constraints. Now you can get an equivalent stiffnes, K, from the results of this static analysis. (K=Defl/Load)
3. Use the (1/2)*M*V^2 = (1/2)*K*X^2 to calculate the approximate deflection that the object will experience due to the kinetiv energy stored just before it hits ground.
4. Repeat 2 if the initial deflection is different than the one obtained in step 4.Also, carefull attention should be given to the constraints used. You probably need to run the analysis three times, one for each direction of coordinates; unless you know experimentally where the object hits the ground. Obviously, the set of constraints should only allow motion in the same direction that the load is applied.
Remember, all of this is linear approximation. Should you need a more accurate way of doing this, then you should really run the analysis with Abacus orother non-linearFEA software.
One more question that I am wondering why I didn't see the termination time intervial in your procedure. Yes, the terminal velocity can be calculated from convertional formula, but how we are going to know the time when the object was hitting the ground.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.