Drawing View Moving on Paper When Adjusting Skeleton

[rob1wal]

When I am changing a dimension on the skeleton within an assembly, the view of the assembly in the draft is moving relative to the paper border.



Is there a way of locking the position of the view so the only movement is that of the part driven by the changing dimension?

 

[stefanba]

Hi rob1wal,



you can fix the origin of the view with view->modify view -> origin. Then you can specify i.e. a datum point as view origin. The location of this datum point on the paper is fixed when you set it as view origin.



hope this helps

stefanba