Cutter Comp Using Trajectory or Volume Mi

[soddyboy]

I am trying to post a program that uses trajectory milling to profile a part and volume milling to make a pocket. My post processor posts correctly when using theprofile command, but does not when using others. I am turning cutcom on in the parameters with no results. What am I missing?


Thanks......

 

[appinmi]

Make sure that the other cuts have "lead ins" and "lead outs". These must be there for Proe to output the "cutcom" command. If you are doing "trajectory" sequences, the cuts must either be "offset" or given a "material side".