Has anybody else noticed this,
The Create Extended Wall feature which extends a sheetmetal wall upto a plane/distance etc normally for creating flush corner joints. You can also use the same function to reduce a wall to a plane/distance. i.e. to change a flush corner joint to an edge to edge joint to run a weld up etc.
This works in 2001 I assume it's the same in Wildfire.
The Create Extended Wall feature which extends a sheetmetal wall upto a plane/distance etc normally for creating flush corner joints. You can also use the same function to reduce a wall to a plane/distance. i.e. to change a flush corner joint to an edge to edge joint to run a weld up etc.
This works in 2001 I assume it's the same in Wildfire.