COSMOSXpress seems to have a bug, where the FOS is twice what it should be and the stress and deformation are half what they should be.
I know no one uses it for any serious analysis, but I was wondering if anyone else experienced this. If so, is there any way to know if this bug carries over to CW?
Background:In a training class that touched on CX, it wasdiscovered that certain computers were yielding different results for the sameanalysis. The part analyzed was a training part- everyone had the same part, and the training book showed what the results should be. We copied a file from a computer that ran it correctly to a different computer, and the FOS results weretwo times that ofthe original computer.The instructorverified multiple times that the setup up was correct.
Edited by: SSLaser
I know no one uses it for any serious analysis, but I was wondering if anyone else experienced this. If so, is there any way to know if this bug carries over to CW?
Background:In a training class that touched on CX, it wasdiscovered that certain computers were yielding different results for the sameanalysis. The part analyzed was a training part- everyone had the same part, and the training book showed what the results should be. We copied a file from a computer that ran it correctly to a different computer, and the FOS results weretwo times that ofthe original computer.The instructorverified multiple times that the setup up was correct.
Edited by: SSLaser