Hi All,
OK, so we switched over the Creo 2.0, and are all starting our every day work with it. SO far, so good.
Maybe not so good...
I have a table top to develop, and the table top is a 'wet table' so it is basically a shallow sink; it has 4 vertical walls. My problem is with the 1/2" radius I want for the internal bend radii (base to vertical walls, the wall to wall is a cut). It'll give me whatever radius I want, but, the two 90° edges that meet to make the radiused corner have a huge gaping gap! Wondering why I can't get this nice & closed.. Any ideas why? or a work-around? Oh, 16GA material... And I've tried a few different ways to achieve my intent, but the end result is always the same, see the attached screen shot..
thanks,
p
OK, so we switched over the Creo 2.0, and are all starting our every day work with it. SO far, so good.
Maybe not so good...
I have a table top to develop, and the table top is a 'wet table' so it is basically a shallow sink; it has 4 vertical walls. My problem is with the 1/2" radius I want for the internal bend radii (base to vertical walls, the wall to wall is a cut). It'll give me whatever radius I want, but, the two 90° edges that meet to make the radiused corner have a huge gaping gap! Wondering why I can't get this nice & closed.. Any ideas why? or a work-around? Oh, 16GA material... And I've tried a few different ways to achieve my intent, but the end result is always the same, see the attached screen shot..
thanks,
p
