Hi there,
I drew an extruded circle. On the top of the circle I cut away a rectangle using extruded cut. Now I have a face on the cut away part where I want to place 3 evenly spaced holes but Ive reached a dead end. Do I need to convert this face to a sketch? If so how do I achieve this? If not then what do I do from here?
Thank you.
I drew an extruded circle. On the top of the circle I cut away a rectangle using extruded cut. Now I have a face on the cut away part where I want to place 3 evenly spaced holes but Ive reached a dead end. Do I need to convert this face to a sketch? If so how do I achieve this? If not then what do I do from here?
Thank you.