Does anyone have any idea why when I pick a "csys" when pro outputs the cl It puts in a X, Y.
$$* Pro/CLfile Version Wildfire 2.0 - M120
$$-> MFGNO / 2ND-OP-RH-PLATE
PARTNO / 2ND-OP-RH-PLATE
$$-> FEATNO / 57
MACHIN / UNCX01, 1
$$-> CUTCOM_GEOMETRY_TYPE / OUTPUT_ON_CENTER
UNITS / INCHES
PPRINT / NC SEQUENCE NAME : FACE-TOP
LOADTL / 1, OSETNO, 1 $$-> 3" FACE MILL
$$-> CUTTER / 3.150000
SET / OFSETL, 54
$$-> TRANS / 0.0000000000, -14.5810000000, 7.9300000000$$-> CSYS / 1.0000000000, 0.0000000000, 0.0000000000, 0.0000000000, $
0.0000000000, 1.0000000000, 0.0000000000, 0.0000000000, $
0.0000000000, 0.0000000000, 1.0000000000, 0.0000000000
90% of the time with my post this is not an issue. If you change "free feed" to a feed rate it will output these as a move in my gcode.
$$* Pro/CLfile Version Wildfire 2.0 - M120
$$-> MFGNO / 2ND-OP-RH-PLATE
PARTNO / 2ND-OP-RH-PLATE
$$-> FEATNO / 57
MACHIN / UNCX01, 1
$$-> CUTCOM_GEOMETRY_TYPE / OUTPUT_ON_CENTER
UNITS / INCHES
PPRINT / NC SEQUENCE NAME : FACE-TOP
LOADTL / 1, OSETNO, 1 $$-> 3" FACE MILL
$$-> CUTTER / 3.150000
SET / OFSETL, 54
$$-> TRANS / 0.0000000000, -14.5810000000, 7.9300000000$$-> CSYS / 1.0000000000, 0.0000000000, 0.0000000000, 0.0000000000, $
0.0000000000, 1.0000000000, 0.0000000000, 0.0000000000, $
0.0000000000, 0.0000000000, 1.0000000000, 0.0000000000
90% of the time with my post this is not an issue. If you change "free feed" to a feed rate it will output these as a move in my gcode.