Automatically activate window

[EddyVE]

Hi,

I am currently trying out a dual monitor configuration with WildFire 4.0.
I have the two monitors configured so they behave as one big desktop.
When I have two or more WildFire windows open, I drag one window to the second monitor. Then I have two windows visible, one on each monitor.
Works fine. One annoyance is that, when moving the mouse pointer from one window to the other, you always have to explicitely active the window that your mouse pointer is over.
I know I can use CTRL-A to activate the window, but it would be nice if this was done automatically

I assume this is asking too much ..?

Kind regards
Eddy





Edited by: EddyVE

 

[Volunteer]

If you have a programmable mouse add Control A to one of the buttons.

 

[EddyVE]

I'm afraid I haven't, but it is a good idea though!

 

[Volunteer]

I have mine set up like that and its pretty handy.

 

[brenyw]

try installing winflip (freeware), it might do what you
want (then again it might not). You can configure it a few
different ways, like flip window when the mouse goes to the
edge of the screen.